How To Replace Your Damaged Garage Door Bottom Seal

Fixing a Broken Seal at the Bottom of Your Garage Door: A Step-by-Step Guide

The seal at the bottom of your garage door serves a vital purpose in keeping out dust, debris, pests, and water from entering your garage. Over time, this seal can become worn, cracked, or damaged, compromising its effectiveness. Fortunately, repairing a broken seal is a relatively simple and cost-effective task that can be done with just a few tools and some basic DIY know-how.

Let's walk through the steps to repair the broken seal at the bottom of your garage door, restoring both functionality and protection to your garage space.

Step 1: Assess the Damage Start by examining the bottom seal of your garage door to assess the extent of the damage. Look for signs of wear, cracking, tearing, or missing sections. Determine whether the seal can be repaired or if it needs to be completely replaced.

Step 2: Gather the Necessary Materials and Tools To repair the broken seal, you'll need the following materials and tools:

  • Replacement seal (available at most hardware or home improvement stores)
  • Utility knife or scissors
  • Soap and water (for cleaning)
  • Adhesive (such as weatherproof sealant or double-sided tape)
  • Measuring tape

Step 3: Remove the Old Seal Using a utility knife or scissors, carefully cut away any damaged or worn sections of the old seal. Be sure to remove all debris and clean the area thoroughly with soap and water to ensure proper adhesion for the new seal.

Step 4: Measure and Cut the Replacement Seal Measure the width of your garage door opening to determine the length of the replacement seal needed. Use a measuring tape to get an accurate measurement, and then cut the replacement seal to the appropriate length using scissors or a utility knife.

Step 5: Install the New Seal Apply a thin bead of adhesive along the bottom edge of the garage door where the seal will be attached. Position the replacement seal along the bottom of the door, ensuring that it is centered and aligned properly. Press firmly to adhere the seal to the door, making sure it forms a tight seal against the ground.

Step 6: Allow the Adhesive to Cure Allow the adhesive to cure according to the manufacturer's instructions before testing the garage door. This will ensure that the seal is securely attached and will provide effective protection against drafts and moisture.

Step 7: Test the Garage Door Once the adhesive has fully cured, test the garage door to ensure that it opens and closes smoothly without any obstruction from the new seal. Check for any gaps or areas where the seal may not be making proper contact with the ground, and make adjustments as needed.

By following the steps outlined in this guide and using the right materials and tools, you can restore the integrity of your garage door seal and keep your garage space clean, dry, and pest-free. Don't want to DIY? Give the team at Ramirez Custom Overhead Door a call.